MR-BEC-45035
Available in: 5V, 6V and user selectable (5v/6v) outputs  


Medusa Research's Battery Eliminator Circuits eliminate the need for a separate battery pack to run the receiver and servos by stepping down the voltage of the main battery. Smaller, secondary battery packs are a nuisance to maintain and charge, take up valuable space, and add weight to your model. Removing them through the use of a BEC frees up the space and weight, and reduces the number of failure-prone parts. The lack of low battery detection on secondary battery packs can result in receiver and servo failure without warning. Medusa Research BECs provide a solution to this problem by tying your receiver and servos into your primary battery. The 3.5 Amp BEC is specifically designed for larger models, and can handle input voltages up to 45 volts! The 3.5 Amp BEC is very light, weighing only 13 grams while a typical receiver and servo battery pack weighs approximately 90. The 3.5 Amp BEC is also very small at 30x50mm, but it requires a minimum input voltage of 8 volts so it is well suited for higher cell count battery packs. Medusa Research BECs save space in your model, can boost performance by improving your thrust to weight ratio, and are a cost effective alternative to secondary battery packs.


3.5 Amp BEC

New: ESC pass-through! No more cutting and removing wires!

Purchase
MR-BEC-45035-5 (5V) Discontinued, replaced by
MR-BEC-45035-5/6
MR-BEC-45035-6 (6V) Discontinued, replaced by
MR-BEC-45035-5/6
New lower price!
MR-BEC-45035-5/6 (5V/6V)

 

  Setting
  5V 6V
Electrical Specifications Min Max Min Max
NiCD/NiMH Cells 10 33 10 33
Li/LiPo Cells 3 10 3 10
Input Voltage 8V 45V 8V 45V
Output Voltage 5.00V 5.15V 5.9V 6.10V
Continuous Output Current No Min 3.5A No Min 3.5A
Peak Output Current No Min 4A No Min 4A
Number of Standard Servos (typical) No Min 8 No Min 8
Physical Specifications
Width 30mm
Length 50mm
Thickness 13mm
Weight w/o wires 13g
Weight w/wires 20g
*Output voltage will be zero for input voltages less than the minimum. For inputs less than the rated output voltage, the output will match the input.
 





This page last updated on Thursday, February 28, 2008
Copyright © 2002 - 2008 Medusa Research. All rights reserved.

web-sites.com™ - site that think

BECs OptoCouplers ESCs Motors Power Analyzers